Centrifuge-free dispersive liquid-liquid microextraction coupled with thin-film microextraction for the preconcentration of molinate in real samples by ion mobility spectrometry
A tandem microextraction method, centrifuge free dispersive liquid-liquid microextraction and thin-film microextraction (DLLME-TFME), was used for analyzing molinate in environmental samples by ion mobility spectrometry (IMS). Considering the IMS as a competitive detection system, coupling these two popular sample preparation methods reduces the effect of solvent interference and improves the sensitivity of the technique.
Trichloromethane and methanol were used as the extraction, and dispersive solvents for the DLLME method and electrospun polyacrylonitrile/copper-benzene-1,4-dicarboxylic acid fibers were used as a sorbent in the TFME method. Some effective experimental variables influencing the extraction efficiency of an analyte such as type and volume of dispersive and extraction solvents, solution pH, ionic strength, sonication time, and extraction time were studied.
The linear dynamic range of 0.5-50 μg L-1 and the limit of detection of 0.1 μg L-1 were obtained under optimized conditions. The relative standard deviations for intra-and inter-day analysis https://biodas.org/ were calculated less than 10%. The present method was used for the determination of molinate in different real samples such as agricultural wastewater, well water, river water, and apple, and the recovery was obtained between 82% and 113%, for the spiked samples.
Acoustofluidic centrifuge for nanoparticle enrichment and separation
Liquid droplets have been studied for decades and have recently experienced renewed attention as a simplified model for numerous fascinating physical phenomena occurring on size scales from the cell nucleus to stellar black holes. Here, we present an acoustofluidic centrifugation technique that leverages an entanglement of acoustic wave actuation and the spin of a fluidic droplet to enable nanoparticle enrichment and separation.
By combining acoustic streaming and droplet spinning, rapid (<1 min) nanoparticle concentration and size-based separation are achieved with a resolution sufficient to identify and isolate exosome subpopulations.
The underlying physical mechanisms have been characterized both numerically and experimentally, and the ability to process biological samples (including DNA segments and exosome subpopulations) has been successfully demonstrated. Together, this acoustofluidic centrifuge overcomes existing limitations in the manipulation of nanoscale (<100 nm) bioparticles and can be valuable for various applications in the fields of biology, chemistry, engineering, material science, and medicine.
Quantitative Evaluation of a Telerobotic System for Vascular Ultrasound Measurement on a Short Arm Human Centrifuge
- Artificial Gravity generated by Short Arm Human Centrifuges is a promising multi-system countermeasure for physiological deconditioning during long duration space flights. To allow a continuous assessment of cardiovascular hemodynamics during centrifugation, a telerobotic robotic system holding an ultrasound probe has been installed on a Short Arm Human Centrifuge.
- A feasibility study was conducted to define the use capabilities and limitations of such a novel method. The objective of this study is to estimate the reproducibility and precision of remotely controlled vascular ultrasound assessment under centrifugation by assessing peripheral vascular diameter and wall distension. Four repeated centrifugation runs of 5 min, with 2.4 g at feet level, were performed including a 15 min rest between each run for a group of eight healthy male volunteers. Vascular diameter and distention were assessed for the common carotid artery (CCA) and the femoral artery (FA) by ultrasound imaging using a 10 MHz linear array probe (Mylab1, Esaote).
- Ultrasound measurements were consecutively performed: a) by an expert user in hand-held mode in standing as well as supine position, b) using the telerobotic arm without centrifugation as baseline and c) using the telerobotic arm during centrifugation. Vascular responses were compared between baseline and under centrifugation. Inter-, intra-registration and group variability have been assessed for hand-held and remotely controlled examination.
- The results show that intra-registration variability, σ h , was always smaller than inter-registration variability, σ m, that is in turned smaller than the inter-subject variability σ g (σ h < σ m < σ g). Centrifugation caused no significant changes in CCA diameter but a lower carotid distension compared to manual and robotic ultrasound in supine position (p < 0.05). Femoral diameter was significantly decreased in hypergravity compared to robotic sonography without centrifugation.
- A good reproducibility and precision of the remotely controlled vascular ultrasound assessment under centrifugation could be demonstrated. In conclusion, arterial wall dynamics can be precisely assessed for the CCA and femoral artery during centrifugation using a telerobotic ultrasound measurement system. Potential improvements to further enhance reproducibility and safety of the system are discussed.
Assessment of bridge natural frequency as an indicator of scour using centrifuge modelling
One of the most prevalent causes of bridge failure around the world is “scour”-the gradual erosion of soil around a bridge foundation due to fast-flowing water. A reliable technique for monitoring scour would help bridge engineers take timely countermeasures to safeguard against failure. Although vibration-based techniques for monitoring structural damage have had limited success, primarily due to insufficient sensitivity, these have tended to focus on the detection of local damage. High natural frequency sensitivity has recently been reported for scour damage.
Previous experiments to investigate this have been limited as a result of the cost of full-scale testing and the fact that scaled-down soil-structure models tested outside a centrifuge do not adequately simulate full-scale behaviour. This paper describes the development of what is believed to be the first-ever centrifuge-testing programme to establish the sensitivity of bridge natural frequency to scour. A 1/60 scale model of a two-span integral bridge with 15 m spans was tested at varying levels of scour. For the fundamental mode of vibration, these tests found up to a 40% variation in natural frequency for 30% loss of embedment.
Models of three other types of foundation, which represent a shallow pad foundation, a deep pile bent and a deep monopile, were also tested in the centrifuge at different scour levels. The shallow foundation model showed lower frequency sensitivity to scour than the deep foundation models. Another important finding is that the frequency sensitivity to “global scour” is slightly higher than the sensitivity to “local scour”, for all foundation types. The level of frequency sensitivity (3.1-44% per scour depth equivalent to 30% of embedment of scour) detected in this experiment demonstrates the potential for using natural frequency as an indicator of both local and global scour of bridges, particularly those with deep foundations.
Microliter ultrafast centrifuge platform for size-based particle and cell separation and extraction using novel omnidirectional spiral surface acoustic waves
Asymmetric surface acoustic waves have been shown useful in separating particles and cells in many microfluidics designs, mostly notably sessile microdroplets. However, no one has successfully extracted target particles or cells for later use from such samples. We present a novel omnidirectional spiral surface acoustic wave (OSSAW) design that exploits a new cut of lithium niobate, 152 Y-rotated, to rapidly rotate a microliter sessile drop to ∼10 g, producing efficient multi-size particle separation.
We further extract the separated particles for the first time, demonstrating the ability to target specific particles, for example, platelets from mouse blood for further integrated point-of-care diagnostics. Within ∼5 s of surface acoustic wave actuation, particles with diameter of 5 μm and 1 μm can be separated into two portions with a purity of 83% and 97%, respectively.
Red blood cells and platelets within mouse blood are further demonstrated to be separated with a purity of 93% and 84%, respectively. These advancements potentially provide an effective platform for whole blood separation and point-of-care diagnostics without need for micro or nanoscale fluidic enclosures.
12 Mini Centrifuge 100-240V (US plug) |
|||
BCM1746 | Bio Basic | 1 pcs, 1 UNIT | 680.54 EUR |
Centrifuge 5910 Ri S-4x750 - EACH |
|||
E5943000564 | Scientific Laboratory Supplies | EACH | 16286.4 EUR |
Centrifuge 5920R no rotor - EACH |
|||
E5948000060 | Scientific Laboratory Supplies | EACH | 13508.1 EUR |
Centrifuge 5920R 15/50mL package |
|||
E5948000460 | Scientific Laboratory Supplies | EACH | 14031.36 EUR |
Centrifuge 5920R 15/50mL package |
|||
E5948000560 | Scientific Laboratory Supplies | EACH | 14281.92 EUR |
Bottle Centrifuge Pp 250 Ml - PK4 |
|||
3141-0250 | Scientific Laboratory Supplies | PK4 | 148.5 EUR |
Bottle Centrifuge Pp 450 Ml - PK4 |
|||
3141-0500 | Scientific Laboratory Supplies | PK4 | 194.4 EUR |
Centrifuge 5920R no rotor- IVD Only - EACH |
|||
E5948000069 | Scientific Laboratory Supplies | EACH | 14176.35 EUR |
F-32x0.2 rotor for centrifuge 5420 - EACH |
|||
E5495404007 | Scientific Laboratory Supplies | EACH | 614.25 EUR |
MyFuge™12 Mini Centrifuge 100-240V (US plug) |
|||
C1012 | Benchmark Scientific | 1 each | 457.47 EUR |
SLS Micro Centrifuge 7000rpm - EACH |
|||
SLS1660 | Scientific Laboratory Supplies | EACH | 270 EUR |
Centrifuge 5920R 15/50mL package - EACH |
|||
E5948000365 | Scientific Laboratory Supplies | EACH | 16443 EUR |
Centrifuge 5420 with rotor IVD ONLY - EACH |
|||
E5420000067 | Scientific Laboratory Supplies | EACH | 2691.9 EUR |
Centrifuge 5420 without rotor - EACH |
|||
E5420000369 | Scientific Laboratory Supplies | EACH | 2072.25 EUR |
FA-24x2 rotor for centrifuge 5420 - EACH |
|||
E5495400001 | Scientific Laboratory Supplies | EACH | 776.25 EUR |
Bottle Centrifuge Sb 250Ml - PK4 |
|||
3123-0250 | Scientific Laboratory Supplies | PK4 | 124.2 EUR |
Centrifuge 5920R 15/50mL package- IVD Only |
|||
E5948000468 | Scientific Laboratory Supplies | EACH | 14742.95 EUR |
Centrifuge 5920R 15/50mL package- IVD Only |
|||
E5948000565 | Scientific Laboratory Supplies | EACH | 14983.49 EUR |
Centrifuge 5420 with rotor FA-24x2 - EACH |
|||
E5420000164 | Scientific Laboratory Supplies | EACH | 2373.3 EUR |